Altrad Belle 150XT Concrete Mixer

The Belle Premier 150XT Concrete Mixer is known for its durability and performance, but like any piece of equipment, it can experience issues. Below are some common problems with the Belle Premier 150XT Concrete Mixer, along with potential causes and solutions:

1. Engine Won’t Start

• Cause:
  • Low or old fuel.
  • Clogged air filter.
  • Dead or weak battery (for electric models).
  • Starter motor failure.
• Solution:
  • Check fuel levels and use fresh, clean fuel.
  • Inspect and clean/replace the air filter.
  • For electric models, check the battery and ensure it is charged or replace it if necessary.
  • Inspect the starter motor and repair or replace it if faulty.

2. Mixer Drum Won’t Rotate

• Cause:
  • Drive belt is damaged, loose, or broken.
  • Motor or electrical failure.
  • Clogged or seized drum mechanism.
• Solution:
  • Inspect and replace or tighten the drive belt if necessary.
  • Test the motor and connections for faults and repair as needed.
  • Check the drum for any obstructions or foreign materials that could prevent rotation, and clear them.

3. Unusual or Excessive Noise

• Cause:
  • Worn or damaged bearings or gears.
  • Loose or misaligned components.
  • Insufficient lubrication.
• Solution:
  • Inspect the bearings, gears, and moving parts; replace worn or damaged components.
  • Tighten any loose bolts or components.
  • Apply lubrication to the necessary parts as per the manufacturer’s recommendations.

4. Excessive Vibration

• Cause:
  • Imbalanced drum load.
  • Damaged or worn out mounts.
  • Loose or broken parts.
• Solution:
  • Ensure materials are evenly distributed in the drum to avoid imbalance.
  • Check the rubber mounts and isolators for wear and replace if necessary.
  • Tighten all bolts and ensure parts are properly aligned.

5. Overheating

• Cause:
  • Prolonged use without breaks.
  • Blocked cooling system.
  • Overloading the mixer.
• Solution:
  • Allow the mixer to cool down during extended use.
  • Clean the cooling vents and ensure airflow is not obstructed.
  • Avoid overloading the mixer by following the recommended load capacity.

6. Concrete Sticking to the Drum

• Cause:
  • Improper cleaning after use.
  • Long mixing times or incorrect speeds.
• Solution:
  • Clean the drum thoroughly after every use, removing all cement and debris.
  • Avoid over-mixing and follow the recommended mixing time and speed settings.

7. Electric Motor Problems (for Electric Models)

• Cause:
  • Faulty electrical connections.
  • Overloaded circuit.
  • Motor failure due to wear or damage.
• Solution:
  • Inspect all electrical connections for damage or loose wires.
  • Check the circuit for overloading and ensure proper fuse protection.
  • If the motor is damaged, repair or replace it as needed.

8. Poor Mixing Performance

• Cause:
  • Worn paddles inside the drum.
  • Incorrect mix ratios or improper material loading.
• Solution:
  • Check the paddles inside the drum for wear and replace them if necessary.
  • Use the proper mix ratios as recommended by the manufacturer.
  • Ensure that the mixer is not overloaded, and materials are loaded evenly.

9. Corrosion and Rust

• Cause:
  • Exposure to moisture and cement residues.
  • Lack of regular cleaning and maintenance.
• Solution:
  • Thoroughly clean the mixer after each use, ensuring all water and cement residue are removed.
  • Apply anti-corrosion treatments or paint on exposed metal parts to prevent rust.

Preventive Tips:

• Follow the manufacturer’s maintenance schedule for oil changes, lubrication, and part replacements.
• Regularly inspect the mixer for signs of wear or damage, and address issues early to avoid larger problems.
• Always use the mixer within its recommended load limits and operational guidelines.

By addressing these common problems and performing regular maintenance, you can extend the lifespan of your Belle Premier 150XT Concrete Mixer and keep it running efficiently. If issues persist, contacting a professional technician – That’s Us!

Spares & parts bibliography

For all spares and parts we recommend our sister company – HTS Spares

Main Parts Page: Belle Premier XT | We have a considerable choice of Belle Premier XT in stock available for next day delivery!

Mixer Mainframe: Belle Premier Mainframe 100Xt, 150Xt | Belle Premier XT Frame 100/150Xt Available with a further 10,000 product lines that can be on your doorstep tomorrow due to a next day delivery service that operates on a nationwide basis. 

Air filters: Premier XT Filters | Browse Premier XT Filters (Yanmar L40) and order online from the UK’s leading supplier of construction machinery parts and accessories. With free delivery.

Mixer Drum Full Assembly: Belle Premier 150XT Mixer Drum With Paddles | Belle Premier 150XT Mixer Drum (Complete With Paddles) | Genuine part

Gear Box:  Belle Premier XT Gearbox | Belle Premier XT Gearbox Supplied by one of the most preferred suppliers in the UK; HTS Spares. Over 10,000 product lines. Same day dispatch.

Electric Motor April 06>: Belle Premier XT Electric Motor | Full Assembly From 2006

Electric Motor Assembly Pre July 2002: Belle Premier XT Electric Motor | Full Assembly Up To 2002